19 Rewa Rewa Rd, Whangarei | 09 438 9689

Icebin 75l Fibreglass LItre Bin

Stock Code:
TSI75F

Description

Prepping your Icebin ice Cooler For Maximum Performance,

Because your Icebin ice Cooler uses such well-designed insulation in this product it will retain cold and heat.
When prepping the cooler for optimal cold performance make sure the cooler is not hot. If you load the cooler after it has been stored in a warm environment and is not cooled before use, you will not realize the coolers full potential.
Try to begin with, and keep, the cooler out of direct sun.


Next lower the inside temperature of the cooler by adding a sacrificial bag of ice several hours before actually packing the cooler for use, if possible, put it in a chest or walk-in freezer for the same amount of time.
This will create a refrigerated mass inside the cooler.
By pre-cooling you will eliminate the heat stored inside the walls and lid of the cooler enabling the cooler to begin at the same temperature as the ice you are about to add and allowing the Icebin Cooler to perform and insulate the way it was intended.
Now empty the water and add cubed ice to the entire bottom area of the cooler.
Use as much cubed ice as possible.
Food, drink and other goods can now be put into the cooler.
It is best to refrigerate or freeze the items before adding them to the cooler.
Leave enough space around the edge and top to add a substantial amount of cube ice and fill all remaining air pockets.
Air pockets speed up the melting of the ice.
Once full and allowing room to close the lid, do so promptly.
During use only open the lid for short periods of time and as little as possible.
This will greatly increase the life of the ice, in turn maintaining the quality and safety of foods and drinks as long as you can.

Cleaning and Maintenance
If you take care of this Icebin Ice Cooler Box it can last your life time.
Before using your Icebin Ice Cooler Box clean the interior with any standard dish washing detergent and rinse. For tough odors, wash with a 1-part bleach and 50-parts water mixture.
Clean the Silicone seal regularly to maintain a good tight seal.
The exterior of the box has been manufactured with a finish to allow ease of cleaning and can usually be cleaned by rinsing and wiping down with a non-abrasive cloth.
If tough dirt remains use a mild dish detergent.
Residue left from oils can be removed easily by using lanolin-based hand cleaner or baby oil.

Do not use alcohol-based cleaners that dry before removing the stain.

Add to Favourites
Make an Enquiry